Rock Wool · Preformed Pipe Section

Rock Wool Pipe Section

Insulvora manufactures preformed rock wool pipe sections for straight pipework. These cylindrical sections can be supplied with a longitudinal split or opening, with foil, glass cloth or external cladding available where required. Matching fabricated insulation pieces can be supplied for associated pipe fittings.

22–910 mmAvailable inside diameter
20–150 mmInsulation wall thickness
600°CMaximum operating temperature

Rock Wool Pipe Section Specifications

Available Specification Range
MaterialRock Wool / Mineral Wool
Density40–200 kg/m³
Inside Diameter22–910 mm
Insulation Wall Thickness20–150 mm
Section Length1 m
Thermal Conductivity0.035–0.042 W/m·K
Maximum Operating Temperature600°C
Combustion PerformanceClass A · GB 8624
OEMAccepted

The inside diameter of a rock wool pipe section must match the actual outside diameter of the pipe. When an order uses DN, NPS or another nominal designation, provide the applicable pipe standard so the required bore can be matched correctly. The dimensions above describe the available range, not a single standard configuration; specific diameter and wall thickness combinations should be confirmed for each order.

Thermal Performance & Application Conditions

Preformed cylindrical sections are intended for straight pipe runs, including systems with repeated lengths or several defined pipe sizes. The shaped bore allows insulation to fit closely around the pipe and helps maintain a consistent thickness, reducing the gaps that may occur when flat blanket is wrapped on site. Actual thermal performance depends on conductivity at the relevant mean temperature, selected insulation thickness and continuity at longitudinal and circumferential joints.

At elbows, tees, valves and flanges, matching fabricated pieces are needed to maintain a continuous insulation layer. Joint positions should also account for pipe supports, maintenance access and interfaces with any protective jacket.

The stated 600°C limit applies to the rock wool material. Facings, adhesives, supports and protective jackets may impose a lower temperature limit on the complete system. Similarly, Class A under GB 8624 describes the product's reaction-to-fire classification; it is not a fire-resistance rating for the installed piping system.

Factory Supply & Order Specification

For a rock wool pipe section order, specify the required pipe sizes and quantities together with any finishing or fitting requirements. Insulvora can supply corresponding section sizes for projects that involve several pipe diameters; provide the required thickness and quantity for each size in the order schedule.

Split & Section Form

Longitudinal split or opening configurations are available for the finished sections. Identify the required form when specifying the order.

Facing & External Cladding

Foil, glass cloth and external cladding are available as project options. State the required option for each relevant section size.

Fittings & OEM Supply

Fabricated insulation pieces for elbows, tees, valves and flanges can be supplied alongside straight sections. OEM orders are accepted within the available product range and confirmed configuration.

Request a Rock Wool Pipe Section Quote

Share the pipe outside diameter or DN/NPS designation with its applicable standard, insulation wall thickness, quantities and any split, facing, cladding or fabricated fitting requirements. Insulvora will review the requested configuration, confirm available options and prepare a quotation for your project or bulk order.